Assembly - Parkside PNTS 1400 G3 Originalbetriebsanleitung

GB IE NI

Assembly

Pull out the mains plug.
Danger of electric shock.
The appliance is supplied with
the cartridge filter (36) fitted.
Steering castor kit assembling
(Fig. A, B)
1. Loosen the handle locking lever (4)
and remove the motor head (5), take
all accessories out of the stainless steel
container (13).
2. Turn the container (13) on the flat
surface, press in the steering castor
kit (15) in the openings at the base of
container (13)
3. Tighten the steering castor kit (15) with
screws supplied.
Assembling upper machine handle
(Fig. A, C)
1. Loosen the handle locking lever (4) and
turn the right / left machine handle (1, 3)
up, lock the handle locking lever (4).
2. Press in the wedge of right / left machine
handle (1, 3) in the slot of the upper
machine handle (2).
3. Tighten the connection with screws
supplied.
Motor head removing / assembling
(Fig. A, D)
1. Loosen the handle locking lever (4)
and turn the upper machine handle (2)
forward.
12
CY
2. Remove the motor head (5) by motor
head handle (6).
3. Insert the motor head (5) into the stainless
steel container (13) with concave riding
on the suction connector (12).
4. Turn the upper machine handle (2) to the
right position and lock the handle locking
lever (4)
5. Turn the handle locking lever (4) clockwise
or anti-clockwise to adjust the tightness.
Cartridge filter / foam filter / dry
dust bag disassembling / assembling
(Fig. A, E)
1. Cartridge filter
• Remove the motor head (5) and place it
upside-down on a flat surface.
• Turn the filter locking screw (38) anti-
clockwise and pull out to remove.
• Pull out to remove the cartridge filter (36)
from the cartridge filter basket (37)
• Put and press in the new cartridge filter
(36) on the cartridge filter basket (37)
with position pins of the cartridge filter
(36) inside the holes of the cartridge filter
basket (37).
• Insert the filter locking screw (38)
and turn clockwise to tighten the new
cartridge filter (36).
2. Foam filter
• Remove the motor head (5) and place it
upside-down on a flat surface.
• Turn the filter locking screw (38)
anticlockwise to unlock the cartridge filter
(36). Remove both and store the parts
carefully for later use.
• Put the foam filter (35) on the cartridge
filter basket (37) till the end-point to
assemble.
• Pull the end of the foam filter (35) to
remove it from the cartridge filter basket
(37).