RIB PARK CRX 120V Bedienungsanleitung Seite 22

G
B
A - CONTROL PANEL FEATURES
J4
J1
S3
TR2
J9
J5
J2
J8
J7
J6
J3 J10
2
J1 L-N Main power supply 230Vac 50/60Hz upon request)
J2 COM Common contact
LSC Closing limit switch contact (NC)
LSO Opening limit switch contact (NC)
LSSC Closing slowing down limit switch contact (NO)
LSSO Opening slowing down limit switch contact (NO)
TLC Vehicle presence signal (NO) (only when switched to PARK mode)
PHOT. NC Photocells contact (NC)
EDGE NC Safety strip contact (NC)
COM Common contact
D+ TEST Safety strip self-test power supply +12Vdc 500mA max
D+ Accessories power supply +12Vdc 500mA max
D- Accessories power supply -12Vdc 500mA max
J3 OPEN 2 Barrier opening button 2 contact (NO) (only when switched to PARK
mode)
SIGNAL Barrier open signal 12Vdc
Buzzer - Acoustic signal connection (12Vdc max 200 mA)
AERIAL Radio antenna
Blinker (max 40W)
J4 U - MOTOR Motor common connection
V-W - MOTOR Motor inverters and condenser connection
J5 OK CLOSE Immediate closure command contact (only when switched to PARK
mode)
OPEN 1 Open1 button contact (NO)
CLOSE Close button contact (NO)
STOP Stop button contact (NC)
K BUTT. Single pulse button (NO)
COM Common contact (common line for all the commands and safety
inputs)
J6 PROBE Heating probe connection terminal block (code ACG4666 optional)
J7 RADIO Built in radio module
J8 AUX. ATT. Card 1 relay connector (code ACQ9080) for management of courtesy
light or boom arm locking magnet
Card 3 relay connector (code ACQ9081) for management of courtesy
light or boom arm locking magnet and traffic lights.
J9 DO NOT TOUCH THE JUMPER!
IF REMOVED THE OPERATOR DOES NOT FUNCTION!
SW PARK
DO NOT TOUCH THE JUMPER!
J10
SW RADIO
IF REMOVED THE RADIO SYSTEM DOES NOT FUNCTION!
S3 PROG. Programming button
TR2 TRIMMER LOW SPEED Slow closure speed electronic regulator
22