Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CA-800-Install.book Seite 28 Dienstag, 12. Februar 2008 3:34 15
Installation
6.2.3 Secure the balance plate
➤ Position the balance plate on the system. To do this, place the four
thread bolts through the four slots in the balance plate.
The balance plate adjusts the roof air conditioner to the specific require-
ments of each vehicle.
➤ Screw one M8 nut each + spring washer + washer (see fig. 3 on
page 3, Pos. 1-3) on to the four thread bolts.
Turn the nuts by hand. The nuts are tightened at a later stage.
6.2.4 Attach the sealing compound to the roof of the driver's
cabin
Make sure that the surface for sticking sealing compound between the ba-
lance plate and the roof of the driver's cabin is clean (free from dust, oil,
etc.).
➤ Stick the 2.5 m long insulating tape (25 x 10 mm) along the contour of
the roof hatch on the roof of the driver's cabin (see fig. 4 on page 4).
➤ Apply a plastic, non-hardening sealing compound (for example, Sika-
Lastomer-710) to the impact edge and the top edge of the insulation
tape.
6.2.5 Install the system in the roof hatch
➤ Position the system in the sunroof opening centrally and in the direc-
tion of travel (see fig. 1 on page 3). The six fastening bolts for the ba-
lance plate must be positioned to fit over the drill holes of the L-shaped
holder.
Make sure the roof air conditioner is centred perfectly. The seal must be
applied continuously around the roof air conditioner after placing it on the
roof of the vehicle. This is the only way to ensure a tight seal.
➤ on the roof of the vehicleAttach the system using the six hexagon bolts
M8 x 18 + spring washers M8 + washers M8 (see fig. 5 on page 4,
Pos. 3, 2 and 1) to the roof of the driver's cabin (L-shaped holder).
Tighten the hexagon bolts with a torque of 10 Nm to attach the sys-
tem.
➤ Tighten the four M8 nuts on the thread bolts (see fig. 3 on page 3,
Pos. 6) by hand again.
28
CoolAir
Werbung
Kapitel
Inhaltsverzeichnis
