Cleaning And Maintenance - Lux Tools 115212 Originalbetriebsanleitung

115212_115213_Trimmer_Benzin.book Seite 59 Mittwoch, 8. Juni 2016 12:23 12
Proper position
DANGER! Risk of injury! If you hold the
motor too high or on the wrong (left) side,
you may cause yourself serious burns on
the hot surfaces. The motor must
– Always be to your right and
– Always behind your body at waist
height.
– The use, guide the strap over the left shoulder.
– Hold the operating bar (3) with both hands.
– Motor (1) and shaft pipe (4/6) are on your right.
– Balance the device and assume a natural
stance.
How to cut correctly
DANGER! Risk of injury! Always switch
the motor off before you set down the
product!
– Check the area you wish to cut and remove any
objects that may be thrown up by the blade.
– Check the safety equipment on the device
before the start of work.
– Starting the motor
– Carry the device as described using the strap
and hold the operating bar (3) firmly with both
hands.
– Push down fully on the gas lever (23). Always cut
at full speed!
Lengthening the thread
DANGER! Risk of injury! When
performing work on the thread spool,
always switch the motor off!
When the unit no longer cuts cleanly, the threads
have become too short.
The best cutting results are obtained when the
thread is lengthened far enough to be cut by the
blade to the correct length.
Lengthening the thread in cutting operation
– Briefly tap the underside of the spool
housing (11) on the ground when the machine is
running.
– If the thread is still not long enough, tap it on the
ground again.
The threads will automatically be cut to the correct
length by the blade.
Lengthening threads by hand
If the threads are too short then they can not be
lengthened by tapping.
They must be pulled from the thread spool housing
by hand.
– Place the product on the floor.
– Using one hand, press the underside of the
thread spool housing and pull both threads out
until they reach slightly further than the edge of
the protective hood (10).
The threads will be cut to the correct length by the
blade next time the unit is used.

Cleaning and maintenance

DANGER! Risk of injury! Prior to
conducting maintenance or cleaning:
– Switch off the motor.
– Allow the device to cool down.
– Remove the spark plug connector.
DANGER! Risk of injury! Carry out only
the maintenance work described here in
person.
All other work, in particular motor
maintenance and repair, must be carried
out by a trained specialist. Improper
maintenance work can damage the
device and lead to injuries.
Cleaning and maintenance overview
After each use
What? How?
Clean the air filter. Clean the air filter.
Clean product. Clean product.
Lubricate the drive Grease press and or-
shaft. dinary lubricating
grease.
Annually
GB
59