Inhaltsverzeichnis
Werbung
2. Turn the horizontal adjust-
ing knob (83) and move the
headstock to the desired
position.
3. Tighten the clamp bolt (E
Adjusting the Spindle Position
The drill table and the spindle are
already adjusted when delivered. If it is
required to readjust the parts, proceed
as follows:
Attention: Make sure the radial drill
press is switched off and unplugged
from power mains before undertaking
any adjustments.
1. Insert a test bar of 80 mm length
into the drill chuck and check with
a right angle ruler if there is a right
angle of the spindle to the drill
table.
2. Unscrew the set screws (45)
on both sides of the bench drill
assembly and adjust it.
3. Tighten both set screws with
the suitable hex wrench.
Adjustments
).
1
Right
Angle
34
Part 83
Test Bar
80 mm
Part 45
firm
Part 73
E
1
slack
Werbung
Inhaltsverzeichnis
