Inhaltsverzeichnis
Werbung
5. Insert the crank (K) for the drill table into the pinion gear (15) and tighten the
crank with the set screw (17) by using the suitable hex wrench.
6. Mount the clamp bolt (11) to the drill table bracket and tighten the clamp bolt.
Fold down the lever of the clamp bolt.
7. Check if the drill table is correctly assembled. By turning the crank the drill
table has to lift up resp. to lower.
Part 72
L
Fasten the Base to a Workbench
1. Mount the base (M) to a firm workbench before operating the radial drill press.
2. For mounting the base use the included hex bolts (94) and wing screws (95).
If necessary use other hex bolts and firmly tighten the bolts. Make sure not to
overtighten the bolts in order not to deform or to damage the base plate.
Make sure the radial
drill press is freely
accessible for use,
adjustments
maintenance.
Assembling
K
and
M
26
Part 94
Part 95
Werbung
Inhaltsverzeichnis
