Intended Use; Unpacking The Tool; Before Use; Setting Up The Battery Charger - Westfalia ASBS 18 Originalbetriebsanleitung

Intended Use

General-purpose cordless combi drill for driving screws and for light
drilling applications, including masonry.

Unpacking the Tool

 Carefully unpack and inspect your cordless combi drill. Familiarise
yourself with all its features and functions.
 Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool.

Before Use

Please note that that battery and charger are not included with the
tool.
Removing a Battery from the Tool
To remove the battery (12) from the tool, press the battery release
button (13), then slide the battery off the hand grip (9).
WARNING: Do not try to remove the battery without pressing the
battery release button. The combi drill or battery could be damaged.
Fitting a Battery
To fit a charged battery, slide it on to the hand grip (9) of the combi drill
until it clicks and locks into position.
Note: Make sure the battery and combi drill are lined up correctly. If the
battery does not slide into the tool easily, don't force it. Instead, slide
the battery out of the tool again, check the top of battery and the combi
drill battery slot are clean and undamaged and that the contacts are not
bent.

Setting up the Battery Charger

(Battery and Charger not included)
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
Note: One LED on the charger will indicate ready status. For further
information please refer to the included manual of the included charger.
Operation
20