Operation; Stand-By Mode; Switching The Appliance On And Off; Locking/Unlocking The Control Panel .Gb - hanseatic HSBS17990WEA1S Gebrauchsanleitung

Operation

Before getting started
• Read chapter "Safety" from page GB-6
and all the safety notices.
• Set up and connect the appliance as
described in chapter "Start-up" from
page GB-32.

Stand-by mode

If no button is pressed for 30 seconds, all
signals on the display will switch off and the
control panel will lock automatically.
To make the signals light up again,
• please press any button.
• please open the door.
To unlock the control panel, press the (21)
LOCK/UNLOCK button down for 3 seconds
until the symbol lights up.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the appliance has been transported
horizontally, lubricant from the com-
pressor may seep into the cooling cir-
cuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting it.
Switching on
1. Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
– When you open one of the appliance
doors, the interior of the appliance is lit
up.
Operation
– The compressor starts to work, the re-
frigerant flows through the pipes and a
quiet humming sound can be heard. The
appliance is switched on.
2. If the appliance makes unusual noises,
check that it is on a solid base and re-
move any objects that are on top of the
appliance.
Switching off
1. Pull the mains plug out of the socket.
– The signals on the control panel disap-
pear.
– When you open one of the appliance
doors, the lights inside the appliance (5)
remain switched off.
– The compressor is switched off. The ap-
pliance doesn't refrigerate.
2. Empty the appliance and clean it (see
"Care and maintenance" on page GB-26).
3. Leave the appliance doors slightly open
to prevent mould from forming.
Locking/unlocking the control
panel
QUICK FRZ
QUICK REF
FILTER RESET /3S
The fridge-freezer is protected against un-
intentional changes in settings. The
bol lights up on the display. If any button is
pressed you will hear a beeping sound and
the (22) signal will flash. The control panel
is locked.
Page GB-13
HOLD 3S UNLOCK UN UN
(22) (21)
sym-