Level One Programming: Functions; Level Two Programming: Parameters - Nice POA1 Anweisungen Und Hinweise Für Den Installateur

7.1.1) Level one programming: functions

At level one, the functions can be activated or deactivated.
At level one, LED P1 is always on; if LEDs L1, L2...L5 are on, the
functions are activated; if the LEDs are off, the functions are deacti-
vated. A flashing LED indicates which function has been selected;
Table "A1" Entering level one programming:
1. Press and hold down buttons P1 and P2 for at least 3 seconds
The programming mode has been entered if all the Leds start flashing quickly
Table "A2" Activating or deactivating a function:
1. Press P1 repeatedly until the flashing Led reaches the function required.
2. Press P2 to activate or deactivate the function.
Table "A3" To pass from part one to part two of level one (and vice-versa):
1. Press P3. button
Table "A4" To exit level one and save the modifications:
1. Press and hold down buttons P1 and P2 for at least 3 seconds
Table "A5" Exiting level one and delete the modifications:
1. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply

7.1.2) Level two programming: parameters

The function parameter can be chosen at level two. Level two can
only be reached from level one.
Table "B1" Entering level two programming:
1. Enter level one programming by pressing P1 and P2 for at least 3 seconds
2. Select the function by pressing P1 until the flashing Led reaches the point required.
3. Enter level two by pressing the P2 button for at least 3 seconds
Table "B2" Selecting the parameter:
1. Press P2 repeatedly until the Led reaches the desired parameter
Table "B3" Returning to level one:
1. Press P1
Table "B4" Exiting level one and saving modifications:
1. Press and hold down buttons P1 and P2 for at least 3 seconds
Table "B5" Exiting level one and cancelling modifications:
1. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply
12
short flashes indicate the function has been deactivated; long flash-
es indicate the function has been activated. Press P3 to pass from
part one programming to part two programming, and vice-versa.
At level 2 the P1 Led flashes quickly while the 5 Leds (L1, L2...L5)
indicate the selected parameter.
Example
P1 P2 3s
Example
P1
P2
Example
P3
Example
P1 P2
3s
Example
P1
3s or 60s,
or
Example
P1 P2
3s
P1
P2
3s
Example
P2
Example
P1
Example
P1 P2
3s
Example
3s P1 or 60s,
or