Exhaust Hose Installation - Midea PH-Serie Bedienungsanleitung

INSTALLATION INSTRUCTIONS (optional)
Fig.16
Expansion plug
position
Adaptor A
Adaptor
cap
Fig.17
Fig.18
max 120CM
min 30CM
Fig.19
Fig.20

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
COOL, AUTO mode
FAN,DEHUMIDIIFY mode
1. Install the window Exhaust adaptor B onto the exhaust
hose as shown in Fig.16. or Fig.17. Refer to the previous
pages for window kit installation.
2. Push the Exhaust hose into the airoutlet opening along the
the arrow direction(See Fig.18).
The exhaust hose can be installed into the wall
(Not applicable to the units without adaptor A, expansion
plugs and wooden screws of Accessories ).
1. Prepare a hole in the wall. Install the wall Exhaust adaptor A
onto the wall(outside) by using 4 expansion plugs and
wooden screws, be sure to fix thoroughly. (See Fig.19)
2. Attach the Exhaust hose installed adaptor B(round mouth)
to wall Exhaust adaptor A.
Note:
Cover the hole using the adaptor cap when not in use.
The duct can be compressed or extended moderately
according to the installation requirement, but it is
desirable to keep the duct length to a minimum.
IMPORTANT:
DO NOT OVER BEND THE DUCT (SEE Fig.20)
CAUTION:
Make sure that there is no obstacle around the air outlet of
the exhaust hose (in the range of 500mm) in order to the
exhaust system works properly.
12 12
Install
Remove