Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11
Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the floor heating actua-
tor, please proceed as follows:
•
Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-
ange (see fig. 7).
•
Release the system button again.
•
Press and hold down the system button again for
4 seconds, until the LED lights up green.
•
Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
12
Maintenance and cleaning
The product does not require any maintenance.
Enlist the help of an expert to carry out any repairs.
The mains voltage must be disconnected before
the device is removed (trip the miniature circuit-
breaker). Only qualified electricians (to VDE 0100)
are permitted to carry out work on the 230 V mains.
Restore factory settings
81
Werbung
Kapitel
Inhaltsverzeichnis
