Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Read and observe the recommendations and instructions supplied with your radio
control system and accessories.
• Do not work on the power system unless the motor is disconnected from the drive
battery.
• When the drive battery is connected, keep well clear of the area around the propeller,
as this represents the greatest risk of accident and injury. Make sure any spectators do
the same.
• Do not exceed the recommended voltage of the drive battery. Increasing the voltage
may cause the motor and / or the speed controller to overheat, and the electrical leads
can even melt. In the worst case this may cause the model to go up in flames and be
completely ruined.
• Check that all the drive train components work smoothly and freely. This applies in
particular when you are running the model, as leaves and other detritus can get caught
up in the power train. If this happens and you do not remove the obstruction, the motor,
speed controller or rudder servo may be ruined due to overloading.
• Ensure that the servos are not mechanically obstructed at any point in their travel.
• Dry cells and rechargeable batteries must never be short-circuited. Do not allow them
to come into direct contact with water.
• Allow the drive motor and speed controller to cool down after each run. Don't touch the
hot surfaces!
• Remove all batteries from the model prior to transporting and storing it.
• Do not subject the model to high levels of humidity, heat, cold, vibration or dirt.
• Secure the model, batteries and RC equipment carefully when transporting them. They
may be seriously damaged if they are free to slide about.
• If you wish to operate the model on moving water (e.g. a river), remember that it could
be washed away downstream if the battery fails or a malfunction occurs.
• If you have to salvage the model, take care not to risk your own life or that of
others.
• Check regularly that the hull is completely watertight, as the model may sink if too
much water enters the hull. Check the boat for damage before every run, and ensure
that water cannot penetrate the hull through the shaft or rudder openings.
• Take care to seal the model before every run, so that water cannot enter. Before
running the boat, ALWAYS seal the hatch cover completely by applying tape all round.
[Seite 3]
Care and maintenance
• Clean the model carefully after every run, and remove any water which penetrates the
hull. If water gets into any of the RC components, dry them out and send them to your
nearest GRAUPNER Service Centre for checking.
• Clean the model and RC components using suitable cleaning agents only. Ask your
model shop for information.
• Lubricate the propeller shaft at regular intervals.
• If the model is not to be operated for a considerable time, it is important to dismantle all
the moving parts (propeller shaft etc.), and clean and re-lubricate them.
3
Werbung
