Motorola MTM800 Bedienungsanleitung Seite 102

• To select a talkgroup, scroll through the talkgroup list
within the selected range. The list shows talkgroups that
are not in the selected scan list. Press Ok.
• To set a priority to a talkgroup, scroll through the priority
list: high, medium, or low.
A call from a high priority talkgroup and with a higher priority
than the on-going call will interrupt it.
A call from a medium/low priority talkgroup will not interrupt
the on-going call.
2. View the contents of the active scan list
(range, talkgroup, and priority if pre-
programmed) by scrolling through it.
3. Edit the scan list talkgroups. Scroll to
your selection and press Optns. Scroll to one of the
following options:
• To Remove a talkgroup from the
selected scan list, select 1 Remove
Grp and press Ok. You will be
prompted to remove the selected
talkgroup. After a few seconds, the display shows the
following talkgroup in the selected scan list.
• To change the talkgroup Priority, select 2 Priority and
press Ok. Scroll to the selected priority and press Ok.
After a few seconds, the display shows the new setting
of the selected talkgroup.
4. To Rename the active scan list, enter a new name (alias)
and press Ok. The display shows the new setting.
5. To Clear all talkgroups from the selected scan list, press
Yes. You will be prompted to remove all talkgroups from the
selected scan list. After a few seconds, the display shows
the new setting of the selected scan list.
96
Range 1
Talkgroup 1
Medium Prior
Back
1 Remove Grp
1 Remove Grp
2 Priority
Back Ok