Cable Routing Diagram - Yamaha WR400F Fahrer- Und Wartungshandbuch

EC240000

CABLE ROUTING DIAGRAM

1 Hose guide
2 Brake hose
3 Regulator
4 Fuel tank breather hose
5 Oil tank breather hose
6 Clamp
7 "ENGINE STOP" button lead
8 Sub wire harness
9 Tail light lead
0 TPS (throttle position sensor) lead
A Neutral switch lead
B Oil hose
C Cylinder head breather hose
D CDI magneto lead
E Hose holder
F Clutch cable
G Decompression cable
H Lights switch lead
I Carburetor breather hose
J Overflow hose
K Coolant reservoir tank breather hose
CABLE ROUTING DIAGRAM
Å Pass the fuel tank breather
hose behind handlebar, then
insert it into the steering shaft
hole.
ı Pass
the decompression
cable, "ENGINE STOP" but-
ton lead and lights switch lead
under where the oil hose is
attached.
Ç Pass the "ENGINE STOP" but-
ton lead, regulator lead and
lights switch lead along the
inner and side of the decom-
pression cable.
Î Fasten the CDI magneto lead,
neutral switch lead "ENGINE
STOP" button lead and lights
switch lead to the frame with a
plastic locking tie.
2 - 21
SPEC
‰ Pass the "ENGINE STOP"
button lead and lights switch
lead along the inner side of
the oil tank breather hose.
Ï Fasten the sub wire harness,
"ENGINE STOP" button lead
and lights switch lead to the
frame with a plastic locking
tie.
Ì Pass
the cylinder
breather hose along the right
side of the oil tank breather
hose.
Ó Fasten the sub wire harness
to the frame with a plastic
locking tie and cut off the tie
end.
È Fasten the TPS lead (in the
sub wire harness) under the
frame.
head