Parameter Table - Gemü SideStep Industrial Schnellanleitung

4

Parameter table

Configuration level Display Function
Mode Select operating modes
1 Service ActiveParaSet Displays the current active parameter set
min-Pot-max Displays travel sensor position in percent
Pot Abs Travel sensor position
Displays the currently connected signal
In open : close
inputs
Deviation between set value and actual
PosCtrlOut
value
Displays the currently connected signals
In 1 : 2
of the digital inputs
Displays the current position of the
Relais K1:K2
internal outputs
Code Passwort entry
Logout Block access
New Code: 1 Release the lowest priority
New Code: 2 Release the medium priority
New Code: 3 Release the top priority
Error List Displays error messages
Warnings Superimpose warnings during operation
Errors Superimpose errors during operation
Clear Error List Delete error list
hrs. Displays the operating hours
V: X.X.X.X Displays the software status
ID Displays the ID-address
S/N Displays the serial number
TAG1 TAG no. 1 can be entered
TAG2 TAG no. 2 can be entered
SideStep
® Industrial
Value range Factory setting
AUTO
AUTO
MAN
OFF
P1...P4 P1
0...10000 0
OK
0...10000 0
0...10000 0
0...10000 0
ON / OFF ON
ON / OFF ON
OK
22 / 28
Configuration level Display Function
2 SetBasics Default Reset to factory setting
Start up behaviour when the supply
PwrOnMode
voltage is connected
SpeedAdj Submenu for setting the speed
StartSpOpe Starting speed in the OPEN direction
Starting speed in the CLOSED
StartSpClo
direction
Stop speed before reaching the OPEN
StopSpOpen
end position
Stop speed before reaching the CLOSED
StopSpClo
end position
Submenu for setting the maximum axial
ForceAdj
forces
Axial force in the OPEN direction during
InitFOpen
initialisation
Axial force in the CLOSED direction
InitFClose
during initialisation
ForceOpen Axial force in the OPEN direction
ForceClose Axial force in the CLOSED direction
Init Valve Starting initialisation
GoClose Scanning the closed position
GoOpen Scanning the open position
D.Refresh Time for display refresh
Dlight Setting the display lighting
Time for an automatic return to the
AutoReturn
working level - Setup
HelpText Superimposes the help text
HelpLanguage Text language
* Depends on sizes, valve type and actuator size
3 SetFunction PosCtrl Submenu for setting positioner parameters
Closing limit = lower position of control
MinPos
range
Stroke limitation = upper position of
MaxPos
control range
Defi nes the range that the valve is closed
CloseTight
under controlled force
Digital Input Submenu for setting the digital inputs
Determines the function of the digital
In 1
input „In 1"
Value range Factory setting
Yes / No Yes
Safe / fast safe
0.0...100.0% 100.0%
0.0...100.0% 100.0%
0.0...100.0% Start
0.0...100,0% Start
0.0...55,0% 45.0%*
0.0...55,0% 45.0%*
0.0...55,0% 45.0%*
0.0...55,0% 45.0%*
0.1...1.0s 0.1s
OnKey / On OnKey
1...60min 5min
ON / OFF ON
D / GB D
0...100% 0.0%
0...100% 100%
0...20% 5.0%
OFF/ON
OFF
Safe/ON
ParmSetB0
ParmSetB1
SideStep
® Industrial
23 / 28