Alesis Photon X 25 Kurzanleitung Seite 15

Assigning the AXYZ dome
Press the EDIT PRESET button and turn the VALUE/ENTER knob until
you see X Ctrl, Y Ctrl, or Z Ctrl. For each of these settings, you can press PAGE
RIGHT button and assign a different MIDI CC number to each of the three axis
(left/right, near/far, and up/down). You can send out AXYZ dome data on a
specific channel by pressing PAGE RIGHT and changing the channel from
Comn to a specific channel from 1 to 16 (see above section for more on this).
Another Way to Assign the Controllers
You can also access and then assign controllers by first pressing EDIT PRESET
and then turning the VALUE/ENTER encoder. The display will cycle through
all of the available controllers.
When you see the controller you want to edit, press PAGE RIGHT. You can
then assign the controller's parameters as listed above.
MIDI SEND BUTTON
(Sending Program, Bank, and Reset MIDI commands)
Press MIDI SEND to send MIDI program change, bank change, and reset
commands.
Sending Program Change commands
Press VALUE/ENTER. The display will read Program Number. Twirl
VALUE/ENTER to find the program change number you want to send. Press
VALUE/ENTER to send the program change message.
Sending Bank Change and Program Change commands
Turn VALUE/ENTER one click, so the display reads Program + Bank. Press
VALUE/ENTER and then twirl it to set the bank number.
Select your MSB and press VALUE/ENTER. Twirl a second time to set the
LSB number and press VALUE/ENTER. Finally, twirl again to set the program
number and press VALUE/ENTER to send the program change.
Sending the MIDI Reset command
Turn VALUE/ENTER two clicks, so the display reads Reset All?
Press VALUE/ENTER two times to send the reset all command.
MIDI PANIC (ALL NOTES OFF)
If your sequencer or hardware device gets "stuck" and stops responding to MIDI
commands, press both PAGE buttons at the same time. This operation sends the
MIDI Panic (all notes off) command, which is designed to solve these sorts of
MIDI problems.
13