Alesis Photon X 25 Kurzanleitung Seite 12

Global settings are in effect at all times, in all presets.
Press the GLOBAL button to access these settings. Then use the PAGE buttons
to cycle through the options. Any changes you make are stored immediately.
When you are finished, press RECALL PRESET to exit this mode and return to
normal operation.
a. LCD CONTRAST.
b. KEYBOARD CURVE.
Exponential, or Always-at-Maximum velocity curve.
c. SEMITONE TRANSPOSITION.
semitones to +11 semitones. You can also use the keyboard to set this value. 0
(no transposition) is equal to middle C.
d. DIRECT MONITOR.
the audio that you send into the Photon X 25 directly, without
requiring the audio to pass through the USB cable to the
computer and back beforehand.
Direct Monitoring is ideal if you want to listen to your
recorded signal with the lowest possible latency. However, if
you turn Direct Monitoring on and also monitor your signal
through your computer, you will likely hear a bit of echo due
to the computer interface's higher latency.
Use VALUE/ENTER to select "enabled" or "disabled"
e. SEND SYSEX.
configurations by sending them to an external device (such as
your computer). Send either one preset or all of them.
10
4. Editing and Storing Configurations
GLOBAL BUTTON
(Editing the Global settings)
Use VALUE to adjust the screen's contrast.
Use VALUE to select the Linear, Logarithmic,
This function allows you to hear
Store your Photon X 25's preset
Use VALUE to cycle from -11
What is Latency?
"Latency" is the delay
between the moment when
audio is generated and the
moment when you actually
hear it. Higher latency
means a longer delay.
Generally, you want to keep
latency as low as possible
while still allowing your
equipment to operate without
glitches.