Reprogramming If A Transmitter Is Damaged Or Lost; Resetting To The Delivery Status; Group Separation - Selve SE Plus-RC Originalbetriebsanleitung

iveo initial operation/Setting by radio

6.6. Reprogramming if a transmitter is damaged or lost

Only use if a programmed transmitter is no longer available (damaged or lost)!
In order to program a new transmitter/channel, the receiver has to be put into repro-
gramming mode by disconnecting it from the mains supply. Subsequently press the
PROG button of the new transmitter for 3 sec. All the old transmitters/channels have
been deprogrammed.
Fuse/Hirschmann plug
3 s 3 s 3 s

6.7. Resetting to the delivery status

To return the motor to the state at delivery, the motor must be brought into service
mode by disconnecting it. Then press the PROG button of an assigned transmitter for
9 seconds.
The motor will then have no transmitters or limit positions saved.
Fuse/Hirschmann plug
3 s 3 s 3 s

6.8. Group separation

A group is an assembly of several motors/receivers that can be controlled by one
transmitter/channel. This transmitter is deleted after the end of the group separation.
During group separation, each motor/receiver will only once move randomly for
3 seconds within a period of time of approx. 2 minutes. Stopping the motor with any
transmitter will programm this transmitter into the respective motor.
New transmitter
➧
3 s
Assigned transmitter
➧
9 s
65
GB
GB