Accessories; Magnetic Tape; Cover Strip; Installation Aid Bam To-Ml-006-S1G (Order Code Bam0256) - Balluff BML-S1G0-.7..-M5E.-.0 Serie Betriebsanleitung

BML-S1G0-_7_ _-M5E_-_0-_ _
Absolute Magnetically Coded Position Measuring System
10

Accessories

Accessories are not included in the scope of delivery and
must be ordered separately.
10.1

Magnetic tape

Absolutcode
Length
Fig. 10-1: Magnetic tape dimensions.
– Length: 9 cm...4800 cm (48 m)
– Measuring range: length – 9 cm
BML-M0_-A55-A_-M_ _ _ _-E
Thickness
2 = Thickness 1.55, comes
with an adhesive layer
(with protective film) for
fastening
3 = Thickness 1.35, without
adhesive layer
Influence of magnetic tape on system accuracy
(total non-linearity)
The measuring system can achieve a system accuracy of
±20 μm.
For a complete technical description and
assembly instructions for magnetic tapes,
please see the magnetic tape user's guide in the
Internet at www.balluff.com/downloads-bml.
10.2

Cover strip

To protect the magnetic tape from damage caused by
chips or chemicals, you may cover it using a stainless steel
cover strip. Note that the permissible gap (Tab. 4-2 on
page 10) between the sensor head and tape is reduced
by the thickness of the cover strip with adhesive layer
(0.15 mm).
Before affixing the cover strip, carefully clean the surface of
the magnetic tape (acetone, turpentine, mild plastic
cleaner, no benzine).
If magnetic tape BML-M0-A55_-A3-M... is
ordered, a cover strip in the same length is
included in the scope of delivery.
www.balluff.com
10+0.2
1.55±0.1 (BML-M02...)
1.35±0.1 (BML-M03...)
Cover strip Length
0 = No cover in cm
strip
3 = With cover
strip
The cover strip can be ordered in 4 defined lengths from a
roll.
Thickness incl. adhesive layer
Width
Length Order code
BML-A013-T0500 BML001J
BML-A013-T1000 BML001K
BML-A013-T2400 BML001L
BML-A013-T4800 BML001M
For a complete technical description and
assembly instructions for cover strips, please see
the magnetic tape user's guide on the Internet at
www.balluff.com.
10.3 Installation aid BAM TO-ML-006-S1G
(order code BAM0256)
56.5
32
25
3.5
Fig. 10-2: Installation aid
10.4 Installation accessories BAM TO-ML-014-01
(ordering code BAM02YC)
The mounting accessories include screws, insulators,
washers, hole template, distance gauge
and Pole Pitch Display Card.
Approx.
0.15 mm
10 mm
5 m
10 m
24 m
48 m
4.2
75
english 29