Sleep-Mode And Wake-Up - Beta URBAN 125 cc Bedienungsanleitung

1

8. SLEEP-MODE AND WAKE-UP

SLEEP MODE - The microcontroller enters
the sleep phase, characterised by low
power consumption when the shift position
switch is in the OFF position.
To conserve power during sleep mode,
every operation normally carried out by
the instrumentation is suspended; the
display and its backlighting are switched
off and only the updating of the current
time remains active.
Sleep mode is always possible, irrespec-
tive of the function selected.
WAKE-UP - Wake-up from sleep mode
occurs when the shift position switch is
in the ON position.
The following occurs immediately after
wake-up of the microcontroller:
● Display and signal indicator check for
approx. 3 seconds
● Screens displayed as shown in fi g. 17
for approx. 3 sec.
● Activation of the last function displayed
before the system went to sleep and
enablement of all functions.
GB
29