Powering On The Projector; Making Adjustments And Selections - Christie LX1750 Bedienungsanleitung

Powering on the projector

Control panel
Power <ON/STAND-BY>
button
Before turning on the power, remove the lens cover.
1) Connect the power plug to the outlet.
(AC 200 V - 240 V 50 Hz/60 Hz)
2) Press the < > side of the main power
switch to turn on the power.
z
z After a moment, the standby indicator <STAND-
BY> will go on and the projector will enter the
standby mode.
3) Press the <ON/STAND-BY> button on
the control panel or the <ON> button
on the remote control.
z
z After a moment, an image will be projected
and the currently selected input signal and
lamp status ( page 85) will be displayed for

approximately four seconds.
Note
z When [PIN code lock] (
[On] using [Security] in the [Setting] menu, enter
your PIN code.
z The projector will make a noise when the lamp
comes on, but this is not a malfunction.
z During projection, the fan rotates, making a sound.
The sound may change depending on the ambient
temperature, and when the lamp is on, the sound
may become loud.
z If the lamp is switched off and immediately on
again, the newly projected image may wobble
for a few moments. This is due to the lamp
characteristics and is not a malfunction.
z When [Direct on] ( page 68) of the [Setting] menu

is set to [On], the power will come on as soon as
you insert the power plug into the outlet or set the
main power switch to the
z When [Display] ( page 59) of the [Setting] menu

is set to [On] and [Logo] (
the countdown will be displayed but the opening
display will not be displayed.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
Remote control
Power <ON> button
page 69) has been set to

side.
< >
page 65) is set to [Off],

z When [Display] ( page 59) of the [Setting] menu is

set to [Off] or [Countdown off], projection will start
as soon as the lamp comes on, regardless of [Logo
select] ( page 65) setting.

z After turning on the power, notes on [Filter warning]
and [Lamp replacement] may be displayed
depending on the status of the projector. (
Making adjustments and
selections
It is recommended that the images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to adjust
the focus of the image roughly.
( page 36)

5) Press the <INPUT 1> to <INPUT 4>
buttons on the remote control or the
<INPUT> button on the control panel
to select the input terminal. (
6) Adjust the projection angle. (
z
z Extend the adjustable feet to adjust the
projection angle.
7) Press the <LENS SHIFT> button to
adjust the position of the image.
( page 35)

8) Press the <ZOOM> button to adjust
the size of the image to fit the screen.
( page 36)

9) Press the <FOCUS> button again to
adjust the focus.
10) Press the <ZOOM> button again to
adjust the zoom and the size of the
image to fit the screen.
Powering on/off
page 86)

page 37)

page 25)

ENGLISH - 33