Turning On The Projector - Christie DHD800 Kurzanleitung

Turning On the Projector

Complete peripheral connections (with a computer,
1
VCR, etc.) before turning on the projector.
2
Connect the projector's AC power cord into an AC
outlet and turn on the MAIN ON/OFF Switch. The
LAMP indicator lights red and the POWER indicator
lights green.
Press the ON/STAND-BY button on the side control
3
or on the remote control. The LAMP indicator
dims red and the cooling fans start to operate. The
preparation display appears on the screen and the
countdown starts.
After the countdown, the input source that was
4
selected the last time and the Lamp status icon
appear on the screen.
If the projector is locked with a PIN code, PIN code
Input Dialog Box will appear. Enter the PIN code as
instructed below.
Enter a PIN code
Use the Point ed buttons on the side control or on the
remote control to enter a number. Press the Point
button to fix the number and move the red frame pointer
to the next box. The number changes to
this step to complete entering a four-digit number. After
entering the four-digit number, move the pointer to "Set. "
Press the SELECT button so that you can start to operate
the projector.
If you fixed an incorrect number, use the Point
to move the pointer to the number you want to correct,
and then enter the correct number.
If you entered an incorrect PIN code, "PIN code" and the
number (✳✳✳✳) will turn red for a moment. Enter the
correct PIN code all over again.
What is PIN code?
PIN (Personal Identification Number) code is a security
code that allows the person who knows it to operate the
projector. Setting a PIN code prevents unauthorized use
of the projector.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector
can no longer be started. Take special care
in setting a new PIN code; write down the
number and keep it on hand. Should the
PIN code be missing or forgotten, consult
your dealer or service center.
DHD800 Setup Guide
020-000247-02 Rev. 1 (01-2012)
The preparation display will disappear after 20
seconds.
Selected Input Source and Lamp control
✔
Note:
• The Lamp replacement icon may appear on
the screen depending on the usage state of the
projector.
8
✳
Repeat
" "
PIN code Input Dialog Box
7 button
✔
• During the countdown period, all operations
except for Zoom, Focus, and Lens-shift functions
are invalid. If the projector has been locked with a
PIN code, however, Zoom, Focus, and Lens-shift
functions are also invalid.
• If you press the ON/STAND-BY button on the
side control or the remote control during the
countdown period, you can skip the countdown
and go to the normal operations.
• If the PIN code number is not entered within
three minutes after the PIN code dialog box
appeared, the projector will be turned off
automatically.
• The "1234" is set as the initial PIN code at the
factory.
- 16 -
16
Lamp status
After the OK icon
disappears, you can
operate the projector.
Note: