[Video Delay Control] - Christie LX1750 Bedienungsanleitung

■ [Effect] z
Sets special effects when shutter is opened and
closed.
1) Select [Effect], and press the
<SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
2) Press ▲▼ to select an item.
[Off] [L 1]
Turns off special effects.
[Off]
z Factory default setting
Sets fade in and fade out when the
[L 1]
shutter is opened and closed.
Sets slower fade in and fade out
[L 2]
than L1.
■ [Release key] z
Sets the release button when shutter is closed.
1) Select [Release key], and press the
<SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
2) Press ▲▼ to select an item.
[Any]
The shutter function is canceled
by pressing any button except the
[Any] <MUTE> button on the remote
control, and the function of the
pressed button is executed.
Only the <SHUTTER> button on the
[SHUTTER] remote control or the control panel
can be canceled.
Note
z If the power is turned on again after the power is
turned off during the setting or the lamp is turned off
with the [Management] setting, the shutter function
is canceled.
z The setting of the selected item is enabled.
■ [Management] z
Sets a time between closing of the shutter and the
lamps turning off.
1) Select [Management], and press the
<SELECT> button.
z ▲▼ are displayed over the sub menu 2. z
2) Press ▲▼ to select an item.
z
z You can set times from 5 - 480 minutes.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
Note
z When the management function is active, the lamp
is turned off and the projector will begin a cooling
operation.
z When cooling has finished, the power of the
projector body is turned off and the standby
indicator <STAND-BY> turns on.
z The shutter indicator <SHUTTER> begins flashing
in blue as the cooling operation begins.
z The flashing continues after the cooling has
[L 2]
finished and the standby indicator <STAND-BY>
has turned on.
z The flashing stops when the projector power is
turned on again.
z The power management function does not work
when the image is blocked by the [Shutter].
z The factory default setting is "180 minutes".
z You cannot set the time while the function is off.

[Video delay control]

Sets when you want to speed up digital processing of
the images being projected.
1) Press ▲▼ to select [Video delay
2) Press the <SELECT> button.
3) Press ▲▼ to select an item.
[SHUTTER]
Note
z The speed of digital processing increases through
[Low], [Mid], and [High].
z When each item is selected, the following items are
grayed out and cannot be selected.
[Setting] menu
control].
[Off]
[High]
[Low] z [Keystone] of the [Screen] menu
z [Progressive] and [Noise
[Mid] reduction] of the [Image adjust]
menu
z [Keystone] of the [Screen] menu
z [Progressive] and [Noise
[High]
reduction] of the [Image adjust]
menu
[Low]
[Mid]
ENGLISH - 71