Installation Instructions - Protector AS-7000 Betriebsanleitung

INSTALLATION
We recommend having the device installed by an
installation technician and heating engineer or by an
electrical installation technician. Correct installation
guarantees the long term, safe operation of the
exhaust air controller. The regional chimney sweep can
and should carry out a function test.

Installation instructions

AS-7000 central unit (receiver) (see figure 2)
Please proceed as follows to install the receiver:
1. Insert the power plug from the exhaust air device into
the socket on the AS-7020/30/40 central unit.
2. Attach the corresponding protective cap (figure S plug
guard) over the plug on the exhaust air device and
screw it in place. If it is not possible to install the plug
guard with the plug inserted then it may be necessary
to adjust the edges of the plug guard slightly or to have
an electrician attach a different plug.
3. Connect the AS-7020/30/40 central unit to the
power socket (power source). Following an internal
self-test the power LED will light up green and
operational readiness is signalled with a beep. For
further information on flashing and beeping patterns
please see the status and error reports.
Installation instructions for the
window transmitter
AS-F20 and the magnet (see figures 9 and 14)
Some points need to be explained and followed in
order to install the window transmitter and the magnet
to the top window frame and to the window
casements. The distance around all sides of the casing
parts must be less than 7 mm and the minimum
opening on the window (table 1) must be achieved.
Please use the included packing parts (U) in order to
adjust the height of the magnet.
NOTE
The window transmitter should not be installed
directly on a metal window frame as this can
reduce ranges.
PREPARATION
Minimum width of window opening
This is based on:
a) The performance of the exhaust air device in m³/h
b) The size of the window to be opened in m²
c) The size of the window opening in cm
(see table 1)
Most kitchens have rectangular tilt and swivel windows.
If you have windows that are, for example, round, then
please ask the installation technician, heating engineer
EN
27