Inhaltsverzeichnis
Werbung
VALVE CLEARANCE INSPECTION AND
ADJUSTMENT
• Measure the valve clearance.
• If the clearance is incorrect, repeat above
steps until specified clearance is obtained.
6. Install:
• O-ring 1
• Crankshaft end accessing screw 2
• Timing mark accessing screw 3
TIP
Apply the lithium soap base grease on the
O-rings.
7. Install:
• O-ring 1
• Exhaust tappet cover 2
• Intake tappet cover 3
TIP
Apply the lithium soap base grease on the
O-rings.
8. Install:
• Spark plug
• Fuel tank
• Seat
Refer to "SEAT, FUEL TANK AND SIDE
COVERS" section in the CHAPTER 4.
3-13
INSP
ADJ
New
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
New
18 Nm (1.8 m · kg, 13 ft · lb)
18 Nm (1.8 m · kg, 13 ft · lb)
13 Nm (1.3 m · kg, 9.4 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
Werbung
Inhaltsverzeichnis
