Electrical Connection Of The Hood - Sirius S-DD2-L FLUSH TOP Bedienungsanleitung

ELECTRICAL CONNECTION
OF THE COOKER HOOD
WARNING
Place the metal box containing the elec-
tronic components at a distance of no less
than 65 cm from gas-operated cook tops or
in any case, 65 cm from the suctioning sur-
face of the cookerhood.
NOTA
We recommend installing the metal box
containing the electronic components at
least 10 cm above floor level and at a suita-
ble distance from all heat sources (e.g. oven
sides or cook top).
CAUTION
This appliance is fitted with an H05 VVF 3
conductor, 0.75 mm2 (neutral, phase, and
ground) power cord.
This can be connected up to a 220 - 240 V
mono-phase electrical network through a
CEI 60083 approved power socket, which
must remain accessible after installation, in
compliance with installation regulations.
We decline any responsibility in case of ac-
cidents caused by a lack of ground connec-
tion or incorrect ground connection. The
appliance must be fed through a differen-
tial protection device (RCD), with a nominal
residual current not exceeding 30mA. If the
power cord is damaged, call the after-sales
service to avoid any risk.
WARNING
The downdraft connection to the electrical
network must be carried out only by profes-
sional and qualified technicians.
The downdraft must be connected to a
properly installed and suitable electrical
network.
The electrical system must comply with
VDE0100 standard.
S-DD2-L FLUSH TOP
EN
DANGER
If the cooker hood presents any anomaly,
disconnect the appliance or remove the
fuse corresponding to the appliance power
disconnecting line.
If the appliance has no plug or if the plug is not
easily accessible, then a device needs to be fit-
ted to cut it off from the electric network; this
device must have an opening distance between
contacts on all poles of at least 3 mm.
ELECTRICAL CONNECTION
This appliance complies with the European
Directives 2006/95/EC (Low Voltage Direc-
tive) and 2004/108/EC (Electromagnetic
Compatibility).
While installing the appliance and carrying main-
tenance operation, make sure it is disconnected
from the electrical network or the fuses are cut
out or removed.
Check that:
• Power is enough.
• Feeder lines (mains) are in good condi-
tions.
• The cables diameter complies with instal-
lation regulations.
NOTA
19