Cleaning The Battery; Cleaning The Charger; Maintenance; Deburring The Guide Bar - Stihl MSA 120 C Gebrauchsanleitung

English
► Clean the oil port (1), oil inlet hole (2) and bar groove (3)
with a soft brush or STIHL resin solvent.
► Clean the saw chain with a soft brush or STIHL resin
solvent.
► Mount the bar and chain.

16.3 Cleaning the Battery

► Clean the battery with a damp cloth.

16.4 Cleaning the Charger

► Disconnect the plug from the wall outlet.
► Clean the charger with a damp cloth.
► Clean the charger's electrical contacts with a soft brush.

17 Maintenance

17.1 Deburring the Guide Bar

A burr can build up on the outer edge of the guide bar.
► Remove burr with a flat file or a STIHL guide bar dressing
tool.
► If you have any queries: Contact your STIHL servicing
dealer.

17.2 Sharpening the Saw Chain

Correctly sharpening saw chains requires a lot of practice.
STIHL files, STIHL filing aids, STIHL sharpeners and the
brochure "Sharpening STIHL Saw Chains" help you achieve
the right results. To obtain the brochure visit
http://www.stihl.com/sharpening-brochure.
STIHL recommends you have saw chains resharpened by a
STIHL servicing dealer.
84
WARNING
The chain's cutters are very sharp. There is a risk of cut
injuries.
► Wear work gloves made of durable material.
► File each cutter with a round file so that the following
points are observed:
– Round file matches the chain pitch.
– File from the inside to the outside of the cutter.
– Hold the file at right angle to the guide bar.
– Maintain a filing angle of 30°.
► File down the depth gauges with a flat file so that they are
level with the STIHL filing gauge and parallel to the service
mark. The STIHL filing gauge must match the chain pitch.
► If you have any queries: Contact your STIHL servicing
dealer for assistance.
17 Maintenance
0458-716-9621-C