Inserting/Charging The Battery; Inserting The Battery; Charging The Battery; Charging Status Indication - FujiFilm instax SQUARE SQ10 Bedienungsanleitung/Fehlerbehebung/Sicherheitsmaßnahmen

Inserting/Charging the Battery

Inserting the Battery

EN
~
Slide the battery cover to open.
Ÿ
Insert the battery according to the arrow on it.
Make sure the yellow line on the battery aligns with
the mark on the camera.
• To remove the battery, press the battery latch to
the side, and slide the battery out of the camera.
!
Close the battery cover.

Charging the Battery

Connect the camera and an AC power adapter supplied
with your smartphone using the supplied USB cable, then
connect the AC power adapter to an indoor power outlet.
8
• Use an AC adapter to meet the rated output below:
DC 5.0 V/1000 mA
• You can take a picture or print an image while
charging is in progress.
• Charging time is approximately three to four hours.

Charging status indication

While camera
Status
is on
->
The (
-> ) icon
While
appears on the lower
charging
right of the LCD
monitor.
The ( ) icon
appears on the lower
Charging
right of the LCD
finished
monitor. (Goes off
when disconnecting
the USB cable.)
An error message
Charging
appears on the LCD
error
monitor.
Charging from a PC:
• Connect the camera and PC directly. Do not connect
them via a keyboard or USB hub.
• If the PC enters the sleep mode while charging is in
progress, charging will stop. If you continue charging,
resume the PC and reconnect the USB cable.
• You may not be able to charge the camera from a PC
depending on your PC specifications, settings, or status.
Caution
• The battery is not charged fully at shipment. Be sure to
charge it before using the camera.
• Read the cautions in "Handling the battery". (Page 36)
While camera
is off
AF illuminator/Self
timer lamp lights up.
AF illuminator/Self
timer lamp goes off.
(The USB cable is
connected.)
AF illuminator/Self
timer lamp flashes.