Safety Notes - IMG STAGELINE PMX-164 Bedienungsanleitung

Powered Mixer
These instructions are intended for users
without any specific technical knowledge .
Please read the instructions carefully prior to
operation and keep them for later reference .
All operating elements and connections de-
scribed can be found on page 2 .
1 Overview
1 Microphone inputs, one for each channel
CH 1 to CH 6 (XLR jacks)
2 Inputs for mono audio sources with line
signal level (e . g . receivers of wireless mi-
crophones, musical instruments), one for
each channel CH 1 to CH 5 (6 .3 mm jacks)
3 Tone controls for the high frequencies
(TREBLE) and the low frequencies (BASS),
one for each channel CH 1 to CH 6
4 Volume controls LEVEL, one for each chan-
nel CH 1 to CH 6
5 Controls EFF to adjust the echo effect part,
one for each channel CH 1 to CH 6
6 RCA jacks LINE to connect a stereo audio
source (e . g . CD/ MP3 player, radio, mixer)
to channel CH 6
7 Overall volume control LEVEL for the echo
effect
8 Control TIME for the speed of the echo
effect
9 Control REPEAT for the number of repeats
of the echo effect
10 6 .3 mm jack LINE IN to return the pro-
cessed signals routed out via the jack LINE
OUT (11)
Note: The internal signal path will be interrupted
when a plug is connected to this jack .
11 6 .3 mm jack LINE OUT to route out the
mixed signal for external processing (e . g .
by means of a dynamic processor or equal-
izer)
Note: The internal signal path will be interrupted
when a plug is connected to this jack .
12 6 .3 mm jack SUB OUT to connect an addi-
tional low-frequency amplifier system (e . g .
active subwoofer)
13 LC display for the audio player/Bluetooth
receiver
14 Control buttons for the audio player/
☞
Bluetooth receiver ( chapter 5 .4)
15 Slot for an SD memory card to replay audio
files
16 USB port (type A) to connect a USB flash
drive for replaying audio files
17 5-band equalizer to adjust the overall
sound
18 RCA jacks CD/ TAPE IN to connect a stereo
audio source (e . g . CD/MP3 player, radio,
mixer, tape recorder)
19 RCA jacks REC OUT to connect a recorder
20 Volume control TAPE IN for the input CD/
TAPE IN (18)
21 Control MASTER for the overall volume
22 Power LED ON
23 POWER switch
24 Mains cable for connection to a mains
socket (230 V/ 50 Hz)
25 Support for the mains fuse
Always replace a blown fuse by one of
the same type .
26 6 .3 mm jacks SPEAKER OUTPUT to connect
one or two speakers with a minimum im-
pedance of 4 Ω each

2 Safety Notes

This unit corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The unit uses dangerous
mains voltage . Leave servic-
ing to skilled personnel only
and never insert anything
into the air vents: Risk of
electric shock!
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water, splash water
and high air humidity . The admissible ambi-
ent temperature range is 0 – 40 °C .
•
Do not place any vessel filled with liquid on
the unit, e . g . a drinking glass .
•
The heat produced inside the unit must be
dissipated by air circulation . Never cover
the air vents of the housing .
•
Do not operate the unit and immediately
disconnect the mains plug from the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case, the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket, always
seize the plug .
•
A damaged mains cable must be replaced
by skilled personnel only .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not correctly connected or
operated, or if it is not repaired in an expert
way . Likewise, no liability will be accepted
for any data loss as a result of operating
errors or a defect or for any consequential
damage caused by this data loss .
•
Important for UK Customers!
The wires in this mains lead are coloured
in ac cord ance with the following code:
green / yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1 . The wire which is coloured green and
yellow must be connected to the ter-
minal in the plug which is marked with
the letter E or by the earth symbol
or coloured green or green and yellow .
2 . The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black .
3 . The wire which is coloured brown must
be connected to the terminal which is
marked with the letter L or coloured red .
Warning – This appliance must be
earthed.
If the unit is to be put out of oper-
ation definitively, take it to a local
.
recycling plant for a disposal which
is not harmful to the environment .
3 Applications
PMX-164 is a monophonic powered mixer
with integrated audio player and Bluetooth
receiver . It will replay audio files from stor-
age media or from your smartphone or
tablet computer by wireless connection .
The powered mixer is designed for versatile
sound applications, e . g . music performances,
speeches or background music . Apart from
microphones, it is also possible to connect
other audio sources (e . g . musical instruments
or CD players) and to add an echo effect, if
desired .
The powered mixer features an insert fa-
cility for processing the mixed signal externally
(e . g . by means of a dynamic processor or
equalizer), an output to connect a recorder
and a low-frequency output to connect, for
example, an active subwoofer .
4 Connections
Always switch off the powered mixer before
making or changing any connections .
4.1 Microphones
Use a cable with XLR plug to connect mi-
crophones to the jack MIC (1) of the input
channels CH 1 – 6 .
For microphones requiring phantom
power, insert a phantom power supply unit .
4.2 Mono audio sources
Connect monophonic audio sources with line
signal level (e . g . receivers for wireless micro-
phones, mixers or musical instruments) to the
6 .3 mm jacks LINE (2) of the input channels
CH 1 – 5 .
4.3 Stereo audio sources
Connect a stereophonic audio source with
line signal level (e . g . CD/ MP3 player, radio,
mixer, output of a recorder) to the RCA jacks
LINE (6) of the input channel CH 6 if you wish
to adjust the sound or add an echo effect .
When an audio source is connected
to the jacks CD/ TAPE IN (18), an individual
sound adjustment or an echo effect will not
be available .
Note: PMX-164 is monophonic; therefore, the two
channels of a stereo signal will be internally mixed
to a mono signal .
,
7