BIELMEIER BHG-650 Bedienungsanleitung Seite 13

Important instructions for use of the appliance:

Thoroughly clean the inside of the appliance
before the first use.

Fill with water before turning on the
appliance.

Do not overfill water container, leave at least
4 cm space below the container rim. If over-
filled, hot water can spurt out.

Caution! Danger of scalding from escaping
steam!

The appliance will become hot when in use
so only grab it on its insulated handles.

Only carry the appliance when it is cool.
Please note the following for the stainless
steel version:
The stainless steel handles are only designed to
act as transport handles when the unit is cold.
Place the appliance in the position in which you
wish to use it. Insert the jars and fill the unit with
water as shown in the drawing (fig. 1). Then in-
sert the plug into an earthened socket only.
Please note the following for the plastics
version:
Please use the appliance just for preserving food,
making juice and preparing hot drinks. It is not
suitable to heat or cook thick liquids directly
in the appliance.
Contrary to the enameled and stainless steel
version this appliance has an open bottom, the
heating element is uncovered.
Caution: improper use may cause
Temperature control (4):
The appliance is equipped whit a precision–
thermostat (capillary tubethermostat). The
(4)
temperature control
approx. 30° C up to boiling. The temperature
set will be controlled automatically. A separate
thermometer is not necessary.
The desired temperature setting is not reached
until the indicator lamp
time and the actual cooking time for preserving,
burns!
is infinitely variable from
(5)
goes out for the first
which is given in cookbooks and indexes, doesn't
start until that moment.
For juice-making the temperature control
has a special marking which renders possible a
permanent heating.
When the cooking process has been completed
or needs to be interrupted, turn the temperature
(4)
control all the way to the left counterclock-
wise and pull the plug.
Hints on cooking:
The boiling point of water varies according to
the local altitude and atmospheric pressure.
If the temperature control
results in continuous boiling and consequently
strong development of steam, loss of water in
the appliance plus wasting of energy.
To find the correct setting for boiling on your
appliance, simply take the following steps:
1.
Turn the temperature control
to the right (clockwise) till „Kochen" (boi-
ling).
2. Wait for the water to boil.
3.
Turn temperature control
the left till the thermostat switches off. This
can be recognized by a lower boiling noise
and a calming down of the steam. In this
thermostat setting the heating element will
be switched on and off automatically.
For the version auto-preserving cooker with
timer:
To regulate the preserving time automatically
the preserver is equipped with a synchronized
timer (6). The timer (6)
1.
Permanent operation ("Dauerbetrieb") on the
far left.
2.
Automatic operation, infinitely setting of the
time up to 120 minutes (dial to the right).
In the position "Dauerbetrieb" (permanent opera-
tion) the timer does not stop automatically. This
setting is used for juice-making or for keeping
warm food or drinks for more than two
* beside appliances made of plastics
GB
(4)
(4)
is set too high it
(4)
all the way
(4)
slowly towards
has two settings:
hours.*
| 13