Other Settings; Energy-Saving Mode - Melitta Solo & Milk Bedienungsanleitung

Descaling phase 2 (
When illuminates, proceed as follows:
■ Ensure that the coffee grounds container
is placed under the steam pipe with the
hose.
■ Turn the valve switch 11 clockwise until
it stops. is fl ashing. Water will fl ow
intermittently into the coffee grounds
container (takes about 10 minutes).
is then illuminated.
■ Empty the drip tray and coffee grounds
container.
■ Reinsert the drip tray and put the coffee
grounds container back under the steam
pipe. illuminates.
■ Remove the water tank and rinse
thoroughly with clear water.
■ Fill the water tank with tap water up to
the max. mark.
■ Insert the water tank.
■ Press the
button to continue with the
descaling programme.
Water fl ows into the coffee grounds
container.
Descaling phase 3 (
When illuminates, proceed as follows:
■ Turn the valve switch 11 anticlockwise
until it stops. Water fl ows inside the
appliance into the drip tray.
■ When
is illuminated, empty the drip
tray and the coffee grounds container
and reinsert them. When
illuminated, the descaling programme is
fi nished.
■ Insert the water fi lter if necessary
("Water hardness and fi lter", page 23).
Operating Instructions: Melitta

Other settings

):

Energy-saving mode

After the last action, the appliance
switches automatically (depending on the
settings) to the energy-saving mode. The
appliance is factory-set at 5 minutes
■ Switch on the device.
■ Press the
■ Press the
■ Press the
is fl ashing.
):
■ Press the
is
Solo & Milk | 1829-0618 | 2018-08
® ®
and
simultaneously until
button twice.
illuminates.
button until one of the four
times is set. The time is displayed by the
beans on display 9.
Display
fl ashing
button to confi rm the
setting.
Other settings
.
buttons
fl ashes.
Time
5 minutes
(factory setting)
15 minutes
30 minutes
off
27