Preparing Small Coffee Quantities; Changing Settings; Setting Warm-Keeping Time; Setting The Signal Tone - Melitta One Bedienungsanleitung

Changing settings

4. Take the filter lid off the filter.
5. Fold a filter along the stamped seam.
6. Fit the filter paper in the filter. Press it
down lightly and into the edges of the
filter.
7. Fill the filter paper with coffee powder
according to the filled quantity of water
and your taste.
8. Close the filter with the filter lid.
9. Push the filter into the appliance. The filter
must click in audibly.
10. Place the jug with fitted jug lid under the
filter.
11. Start preparation with the "Start/
Stop" button.
» The "Start/stop" button will flash.
» The preparation ends automatically. The
"Start/Stop" lamp lights up and a signal
tone sounds depending on the setting.
» The water tank illumination goes out.
4.3 Preparing small coffee
quantities
The "Small Quantity" button extends the
brewing time. As a result, you will get an
aromatic, full coffee flavour even when you
prepare small coffee quantities (2 to 5 cups).
Proceed in the way described first of all, see
chapter 4.2 Preparing coffee.
Press the "Small Quantity" button before
starting preparation. Activation is
confirmed by the illuminated lamp.
Then, press the "Start/Stop" button. The
"Small Quantity" lamp flashes during
preparation.
16
5 Changing settings
5.1 Setting warm-keeping
time
The taste of coffee changes when it is kept on
the hotplate for longer periods. It becomes
bitter. To prevent this, you should enjoy your
coffee as fresh as possible immediately after
preparation. Also, unnecessarily keeping the
coffee warm costs valuable energy.
The appliance is factory-set for a warm-keep-
ing time of 30 minutes. This time can be
changed.
1. Press the "Start/Stop" button for
longer than 2 seconds.
» The "Start/stop" button will flash.
» The water tank is illuminated.
2. Press the "Start/Stop" button
repeatedly until the desired
warm-keeping time is set. The flashing
rhythm indicates the set warm-keeping
time, see the following table.
3. Press the "Start/Stop" button for
longer than 2 seconds to save the
setting.
The setting is retained even when you discon-
nect the appliance from the electricity mains.
Warm-keep- Flashing rhythm
ing time
"Start/stop" lamp
0 minutes
n n
30 minutes
nn nn
60 minutes
nnn nnn

5.2 Setting the signal tone

The end of brewing is indicated by a signal
tone. The signal tone can be set.
1. Press the "Small Quantity" button for
longer than 2 seconds.
» The "Small Quantity" lamp flashes.
» The water tank is illuminated.
2. Press the "Small Quantity" button
repeatedly until the desired signal
tone is set. The flashing rhythm indicates
the set signal tone, see the following table.
3. Press the "Small Quantity" button for
longer than 2 seconds to save the
setting.