Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xplorer Originalbetriebsanleitung

6.6

Switching the clipper on and off

Fig. 9
6.7

Using the clipper

Approach the animal from the front.
X X
Secure the animal to be clipped and calm it down.
X X
Switch the clipper on while you are in the visual range of the animal.
X X
Observe the animal's behaviour while clipping.
X X
Switch the clipper off after you have finished clipping.
X X
6.8

Replacing the clipping blades

Fig. 10
Fig. 11
Fig. 12
Instruction Manual / Cattle and Horse Clipper
To switch the clipper on, slide the
X X
ON/OFF switch to the position I.
To switch the clipper off, slide the
X X
ON/OFF switch to the position 0
(see Fig. 9).
Switch the clipper off by sliding the
X X
switch to the position "0".
Turn the adjusting knob in the direc-
X X
tion of the arrow until the resistance
decreases.
Place the clipper with the comb plate
X X
screws facing upwards on a flat sur-
face.
Loosen the comb plate screws and
X X
remove the clipping blades.
NOTE!
Make sure the clipping blades are
X X
positioned correctly when installing
the new or sharpened blades.
15