Charging Status Display; Adjusting The Clipping Pressure; Switching The Clipper On And Off; Using The Clipper - Heiniger Xplorer Originalbetriebsanleitung

7.4 Charging status display

The LEDs are shown as follows in these operating instruc-
tions:
1 LED switched off
2 LED lights up red
3 LED lights up green
Four charging statuses are displayed with the LEDs:
AC adapter connected
The continuous green light on the lower LED signals that
the AC adapter is correctly plugged into the power socket.
The charger is supplied with power and is ready to ope-
rate.
Normal charging
The three LEDs light up red if the battery is discharged. The green light indicates that the
battery is charged. The charging process is displayed differently depending on the residu-
al voltage:
Discharged battery, 0 % battery charge
approx. 30 % battery charge
approx. 75 % battery charge
approx. 90 % battery charge
Deep discharging
_
With a deeply-discharged battery, the LEDs flash red and
_
green alternately. The charger attempts to charge the bat-
tery. If the voltage does not increase after a short while, the
display shows "Battery defective". If it is successful, normal
charging starts.
36

7.5 Adjusting the clipping pressure

Abb. 8
►

7.6 Switching the clipper on and off.

Abb. 9

7.7 Using the clipper

Approach the animal from the front.
‹
Secure the animal to be clipped and calm it down.
‹
Switch the clipper on while you are in the visual range of the animal.
‹
Observe the animal's behaviour while clipping.
‹
Cattle and Horse Clipper Cattle and Horse Clipper
Defective battery
1
If the battery cannot be charged or the battery is defective,
2
the top LED flashes red.
3
Set the clipping pressure as follows before you start
clipping:
Turn the adjusting knob in the direction of the
‹
arrow until you feel resistance.
Turn the knob another 1/4 turn in the direction
‹
of the arrow.
If the clipping quality deteriorates, increase the
‹
clipping pressure by turning the adjusting knob
another 1/4 turn in the direction of the arrow.
If this does not produce the desired result, the
blades must be replaced or sharpened.
NOTE
If the clipping pressure is too low, hair can gather between the clipping blades. This
results in a poor clipping quality. In this case, clean the clipping blades as described in
chapter 7.10.
To switch the clipper on, slide the ON/OFF
‹
switch to the position I.
To switch the clipper off, slide the ON/OFF
‹
switch to the position 0 (see Fig. 9)
37