Data Entry (General Description); Barcode Scanner - Rothenberger ROFUSE 400 TURBO Bedienungsanleitung

Multi-functional keys:
SETUP ........... You use this button to navigate to the Setup menu. It is here that settings such
INFO ............... This is where extensive information about the device can be retrieved such as
USB ................ The stored welding sequences can be transferred from the internal memory of
WELDING ....... One uses this multi-functional key to navigate to "Data entry" in order to start
7.2

Data entry (general description)

The majority of data can be entered either manually or by means of a barcode scanner.

Barcode scanner

A barcode is read in in that a barcode scanner is held at a distance of about 5 - 10 cm in front of
the barcode. If the barcode scanner is in Standby mode, shortly press the button on the hand-
grip of the scanner; the scanner switches on. The red line displays the reading area. Press the
button on the handgrip again. The barcode is read in. If the data is recognised and stored cor-
rectly a signal tone sounds and the read in data are displayed as clear text (numbers / letters) on
the welding equipment display. If the scanned in barcode matches the expected barcode, the
welding equipment also confirms the correctness of the barcode with a signal (for example the
welding equipment does not accept it if, at the point in the welding process at which the fitting
barcode should be scanned in, the barcode for the fitting traceability is scanned in instead).
Attention! A class 2 laser – never look directly into the laser beam!
Manual Input of data (letters and numbers)
Using manual entry allows both data, such as the name of the welder or the construction site, or
also the number sequences which are encoded in the barcode, to be entered, for a case where
this is illegible or the barcode reading device is defective. Letters and numbers can be entered
over the displayed alpha-numeric keyboard. The letters or numbers are located (selected) by the
arrow keys. Press OK to confirm the selection. Press the >arrow downwards< and >OK< but-
tons, one after the other, after completing the data entry. Letters and characters can be deleted
by actuating the >STOP< button.
22
as the time, languages, methods for data entry and scheduled maintenance
dates are set.
the serial number, owner, etc.
the device to a USB memory medium using the USB menu.
welding.
ENGLISH