Assembly Of Cutting Units To Machine - Ransomes Fairway 250 Sicherheits Und Bedienungs Anleitung

GB-NL-F-32
Fig.18
Fig.19
Fig.20
ASSEMBLY OF CUTTING
UNITS TO MACHINE
PREPARATIONS
l
Unpack the cutting units and distribute them
around the tractor near the attachment points.
l
For each cutting unit, lubricate the inside of the
housing where the hydraulic motor attaches.
l
Locate the five, round couplers shipped loose
with the tractor.
ATTACHING THE CUTTING UNITS
1. Lubricate coupler C Fig.18 with non-tracking
grease and insert it (either side of coupler) into
the motor attachment housing A Fig.18. Press
the coupler firmly on the reel tang at the rear.
NOTE: Detents in the coupler allow it to be
attached to the tang only one way.
2. Smear additional grease on the installed coupler
until the cavity is about 1/2 full.
3. Line up the tang on the shaft of the hydraulic
motor B Fig.18 so that it is approximately
perpendicular to the reel tang (small adjust-
ments are made by slightly rotating the reel).
Adjust so that the motor seats snugly against the
cutting unit flange and attach motor with studs D
fig.18, nuts E Fig.18 and S.L.washers f Fig.18
4. Take the pivot shaft out of the tractor cutting unit
arm by removing end bolt B Fig.19.
5. Remove retaining collar C Fig.19 from the pivot
shaft.
6. Insert the pivot shaft into the yoke of the cutting
unit and secure by replacing retaining collar C
Fig.19.
7. Line up the pivot shaft with the tractor arm and
re-insert. Secure shaft with bolt B Fig.19.
8. Attach chain A Fig.20 to cutting unit with pin.
Secure with cotter.
After attaching all cutting units, perform adjustments
and set cutting heights with reference to the sepa-
rate operator's manual for the cutting units.
GB