B) Charging Accumulators Without Balancer Connection („Charge") - VOLTCRAFT VC-1506 Bedienungsanleitung

b) Charging accumulators without balancer connection („Charge")
After selecting „CHARGE", the following display appears, for example:
• If the values need to be changed, press the „Start/Enter" button.
- +
Start
Enter
• You should be aware while doing this that the voltage only changes with the number of cells (e.g. one cell = 3.7V,
two cells 7.4V etc.)
• Confirm the setting by pressing the „Start/Enter" button.
• To start the charging, hold the „Start/Enter" key depressed for approx three seconds.
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate infor-
mation is shown on the display.
• You can stop the audio signal by pressing the „Batt Type/Stop" button. You then return to the previous configura-
tion menu.
• If the settings are wrong, the following display appears (alternating):
•
•
78
The value on the left in the second line shows the charge current,
the value on the right shows the voltage or number of cells of
the accumulator pack (in this example, a 3-cell LiPo accumulator
pack, 3x3.7V=11.1V)
The charge current begins to flash. Change the charge current
using the buttons „+>" and „
Enter" button.
The voltage then begins to flash. Change it using the buttons „+>"
and „ ".
- + -
<
The battery charger then starts a check of the battery pack con-
nected.
", confirm the value using the „Start/
-
<