Safety Information About Usage; Mounting Of Door Bar; Tools Required - Crivit TR-1433 Bedienungsanleitung

safety information about usage

- The use of this article is carried out at your own risk.
- This article must only be used by people who are familiar with the safety information.
- Check that the article is securely fixed (wedged) before each use.
- This product should only be used when the colour identification window display is completely
green.
- Do not load the article with more than a total load of 100 kg.
- Before each use, check again that the article is securely fixed, using pulling and shaking
movements.
- Not suitable for the attachment of dynamic accessories, for example, swings.
- Do not carry out any exercises in which your head points to the floor.
- Do not swing on the bar!
- The article must always be used by only one person at a time.
- The article is only suitable for private use.
- The article must only be used under adult supervision, and must not be used as a toy.
- Check gym equipment for damage and wear and tear before starting every training session.
If you find damage, you should no longer use the equipment.
- If you have health problems, ask your doctor before you use the item. If during the exercises
you should feel unwell or experience discomfort, stop the exercises immediately and seek
medical advice!
- Pregnant women should only carry out the training programme after consultation with their
doctor.
- Carry out the exercises with sufficient space between you and any objects or other people that
nobody can be injured.
- Keep the operating instructions in the vicinity of the training apparatus. These will serve as a
reference for the main exercises.

Mounting of Door Bar

fig. 1
out

tools required

To screw the door exercise bar into the doorframe, you will need a crosshead screwdriver and a
suitable corresponding drill.
note:
A rubber ring is located inside each end cap. What if the rubber ring
comes out of the end cap during installation or removal? Simply replace
into the end cap as shown in fig. 1. The smooth side labelled „out" should
be facing the open end of the end cap.
5