D) Mounting The Tail Rotor Servo; E) Mounting The Flight Control System - Reely SKY Blue Twister Bedienungsanleitung

d) Mounting the servo of the tail rotor
• First fasten the servo of the tail rotor (1) at both brack-
ets, which are mounted onto the tail bar.
• Determine afterwards the exact position of the joint ball
(2) on the servo lever.
The position must be selected in such a way that the
steering linkage (3) for the tail rotor runs perfectly
straight.
The distance of the joint ball from the pivotal point of
the servo lever should be approximately 7 – 8 mm.
• After you have mounted the linkage at the servo lever
and directed it in an angle of 90° to each other, move
the servo of the tail rotor including the mount so that
the inner edge (4) of the steering lever on the lower
side of the tail rotor mechanics runs parallel to the tail
bar (5).
Afterwards firmly screw the servo mount in this position
to the tail bar.

e) Mounting the flight control system

• The flight control system (1) is glued with servo tape or
double-sided adhesive tape on the support plate.
• Afterwards, the motor cables are secured additionally
with a stripe of adhesive film or with a cable fastener.
Attention!
Make sure that the cables do not get in the rotation area of the external rotor motor or in the drive
Figure 8
Figure 9
33