Retrofit; Padfoot - Ammann ACR 68 Originalbetriebsanleitung

6. Retrofit

6.1 Padfoot

6.1.1 Installing the shortener and extensions
For changing the working height, a tamping place shortener and
two extensions are available. For this the adaptor between the
padfoot and the suspension strut must be replaced.
•
Lay the tamper on a firm, even surface (not on the carburettor
side).
2
B6899546
•
Loosen and remove the padfoot (1) and handle (2).
B6899547
•
Loosen and remove the adaptor (3).
Keep the adaptor safe for later use.
Important
1
B6899548
•
3
B6899549
•
6x
53
40 Nm
Tightly screw on the adaptor or foot extension (4).Pay atten-
tion to the installation position.
2
60 Nm
Install and tighten the padfoot (1) and handle (2).
4
6x
1
2x