Working With The Tamper; Setting The Working Height - Ammann ACR 68 Originalbetriebsanleitung

3. Operation
3.3.4 Shutting off the motor
In emergency situations, turn the motor switch to
«OFF» to shut off the motor.
Important
B6899510
MAX
5
•
Set the accelerator lever (5) to «MIN».
OFF
•
Turn the motor switch (6) to «OFF».
3
•
Set the fuel tap (3) to «OFF».
MIN
ON
6
OFF
ON

3.4 Working with the tamper

3.4.1

Setting the working height

Setting the guide bar out of the optimal position
can increase hand/arm vibration. This must be
considered when determining the exposure pe-
Attention
riod.
Setting the guide bar out of the optimal position can increase
hand/arm vibration.This must be considered when determining
the exposure period.
2
1
B6899513
•
Loosen the screws (1) enough so that the bracket moves up
and down. Do not take them completely out.
•
Set the working height by turning the guide bar (2).
•
Tighten the screws (1).
1
B6899511
B6899551
•
To set the ergonomically optimal position
-
Loosen the screws (1),
-
Set the markers above one another.
-
Tighten the screws (1).
B6899512
39