Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Care & Maintenance - ANSMANN ENERGY8 plus Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
ENERGY 8 PLUS
Alkaline Detection
Automatic switch to top-off charge and trickle
charge
Clear coloured LED indicators show the rechargeable
battery status
Integrated switch mode power supply (100-240V AC
/ 50-60Hz) for worldwide use
BATTERY QUICK TEST
After inserting the batteries, the state of charge
is displayed:
LED green: capacity over 80% of the nominal
capacity
LED orange: capacity between 25% and 80% of the
nominal capacity
LED red: capacity lower 25% of the nominal
capacity
After 5 seconds, if the batteries are not removed,
the unit switches over to automatic refreshing/
charge mode.
LED INDICATORS / CHARGE MODES
LED flashes red/green „refreshing" -> refresh
mode
LED flashes green „Pre-Charging" -> Pre-charge
mode
LED lights red „Charging" -> Fast charge mode
LED lights green „ready" -> battery fully charged
/ top-off or trickle charge mode
LED flashes red „Error" -> faulty battery or alkaline
battery detected

OPERATION

Connect the charger to mains (100-240V AC /
50-60Hz). To insert cylindrical cells, move the
silver contact bridge backwards and put in the
rechargeable battery at the bottom of the charging
slot. Always connect the cells in the right direction
for polarity (according to the symbols in the
charging slots). The charger is equipped with 2 dual
slots for cylindrical cells. In each of these charging
positions you can either insert 2pcs of Micro AAA or
Mignon AA cells or 1pc of Baby C or Mono D cells.
When inserting Baby C or Mono D cells both contact
bridges must fit closely on the battery and the
cells must be located centrally. After inserting the
batteries, the state of charge is displayed for about
5 seconds. If required the unit starts pre-charging
or refreshing (depending on the capacity level of
the battery to be charged) for each charging circuit
separately before it switches over automatically to
the fast charging process. It is normal that batteries
may become warm during charging. After charging
is complete, the charger switches automatically
to top-off charge and a short time later to trickle
charge. The trickle charge prevents the self-
discharge of the batteries when left in the charger.
They may be left in the charger until used.
ENVIRONMENTAL COMMENTS
Do not dispose the device in the normal household
waste. Please return it to your dealer or to your
nearest recycling centre or collection point. Please
recycle all packing materials for the sake of the
environment.
CARE & MAINTENANCE
To make sure that the charger works properly,
please keep the contacts in the charging slots
free from dust or contamination. To clean the
unit disconnect it from the mains and use only a
dry cloth.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis