Unpacking Rotopol-31/-35; Placing Rotopol-31/-35; Supplying Power; Rotopol-31 - struers RotoPol 35 Gebrauchsanweisung

Unpacking RotoPol-31/-35

Placing RotoPol-31/-35

Supplying Power

RotoPol-31

Direction of the Turntable
on RotoPol-31
RotoPol-35
Single-phase Versions
RotoPol-35
Three-phase versions
4
RotoPol-31/-35
Instruction Manual
Detach RotoPol-31/-35 from the bottom of the packing case by
removing the four screws from below.
Place RotoPol-31/-35 on a steady table with an adequate working
height. The machine must be close to the power supply, water
mains and water outlet facilities. If water recirculation is used,
there must be room under the table for the Recirculation Cooling
Unit (TRECI).
RotoPol-31/-35 is factory mounted with electric cable.
Check that the mains voltage corresponds to the voltage stated on the type
plate on the back of the machine.
Mount a plug on the cable or connect to mains:
Yellow-green or just green: earth
Other colours: phase
Check that the turntable rotates in the direction indicated by a
label on the turntable (anti-clockwise). If the direction of rotation
is incorrect, switch two of the phases.
Mount a plug on the cable or connect to mains:
Yellow-green: earth
Blue or white: neutral
Other colours: phase
Mount a plug on the cable or connect to mains:
Yellow-green or just green: earth
Other colours: phase
IMPORTANT
DANGER!
The machine must be earthed