Use With An External Dmx Controller - Renkforce DL-PAR103 Bedienungsanleitung

AUTO RUN
This button activates automatic mode.
Push the button AUTO RUN. Use the buttons +/- or the number buttons to select the corresponding pro-
gramme. Push the button SPEED. Use the buttons +/- or the number buttons to select the desired speed for
the programme process or the strobe effect.
FADE MODE
This button activates the FADE mode.
Push the button FADE MODE. Select the corresponding FADE programme with the buttons +/- or the
number buttons. Push the button SPEED. Use the buttons +/- or the number buttons to select the desired
speed for the programme process.
COLOR MODE
This button activates the COLOR mode
Push the button COLOR MODE. Select the corresponding colour with the buttons +/- or the number but-
tons. Push the button SPEED. Use the buttons +/- or the number buttons to set the strobe setting.
R G B W/A button
Use these buttons to set the brightness of the colour red, green, blue or amber.
Push the button R, G, B or the W/A button. Use the buttons +/- or the number buttons to set the corres-
ponding colour brightness. Push the button SPEED. Use the buttons +/- or the number buttons to set the
strobe speed. The strobe effect is deactivated for the setting 0.
Set addr
Push the button Set Addr (S_A). Enter the DMX address with the number buttons. Setting with the buttons
+/- is not possible here.
Set Channel Mode
Push the button Set Channel Mode (S_C). Set the corresponding DMX mode with the buttons +/- or the
number buttons 1-8.
i) Use with an external DMX controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light re-sponds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires up to 8 DMX channels.
35