Mains Connection; Operation; Setting The Operating Mode - Renkforce DL-PAR103 Bedienungsanleitung

9. Mains connection

The mains socket to which the effect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause
potentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Before plugging in the mains plug, ensure that the device voltage indicated at the effect light
corresponds to the available mains voltage. Do not connect the device if the indication does not
correspond to the available mains voltage. Incorrect supply voltage may lead to irrepa-rable
damage to the device and danger to the user.
• Connect the mains connector of the mains cable into the mains connection POWER IN at the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
Up to 10 DL-PAR103 in a row can be connected via the POWER-IN and POWER-OUT sockets.

10. Operation

a) Setting the operating mode
The effect light can be controlled with the integrated controller, the remote control or with an external
DMX controller.
If an active connection to a DMX-controller has been created, the buttons on the rear of the
device can only be used to set the DMX address, and the DMX mode (Ch1-Ch8).
Use the LED display and function buttons MODE, SET UP, UP and DOWN to set the operating mode.
• Push the button MODE to choose the setting mode.
• Push the button SET UP to choose the submenu.
• Select the desired operating/setting mode with the UP and DOWN buttons.
The display automatically returns to the MODE setting after a few seconds.
29