Use With An External Dmx Controller - Renkforce MINIPAR 18 x 1 W Bedienungsanleitung

b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identi-
fied by the controller. This DMX starting address specifies the first DMX channel to which the
effect light responds. The remaining control channels come after this first DMX channel (DMX
starting address).
The effect light requires 3, 5 or 7 free DMX channels depending on operating mode.
Setting the DMX starting address
• Push the button MENU (3) until "Addr" is displayed and push the button ENTER (6).
• Select the desired start address A001-A512 with the UP (4) and DOWN (5) buttons.
• Press the ENTER button (6) to confirm your selection.
Setting the DMX operating mode
• Push the button MENU (3) until "CHnd" is displayed and push the button ENTER (6).
Select the desired operating mode with the UP (4) and DOWN (5) buttons:
3CH 3-channel DMX mode
5CH 5-channel DMX mode
7CH 7-channel DMX mode
• Press the ENTER button (6) to confirm your selection.
The following tables provide information about the effects of the settings on the individual DMX
channels.
3-channel DMX operation
DMX channel Value
1 000-255
2 000-255
3 000-255
Function
Brightness setting red dark > bright
Brightness setting green dark > bright
Brightness setting blue dark > bright
39