Cleaning And Maintenance - Bionaire GLASS BASE BAOF30G Betriebsanleitung

BAOF30GI06MLM1.qxd 12/15/06 14:30 Page 4
Fig. 1
M
L
D
N I
J
F
O
B
A
A
Fig. 2 Fig. 3
H
B
H
C B
Fig. 2
Fig. 5 Fig. 6
Fig. 6
F
I -(2)
D
Fig. 8
Fig. 8
M
F
N
O
ENGLISH
K
PLEASE READ AND SAVE THESE
P IMPORTANT INSTRUCTIONS
G
Q When using electrical appliances, basic safety
precautions should always be taken including
the following:
E
• Use the fan only for purposes described in
the instruction manual.
• To protect against electrical shock, do not
immerse the fan, plug or mains cable in water
A
or spray with liquids.
• Close supervision is necessary when any
H
appliance is used by or near children.
• Unplug from the electrical outlet when not in
use, when moving the fan from one location
to another, before putting on or taking off
C parts and before cleaning.
• Avoid contact with any moving parts.
• Do not operate in the presence of explosives
and/or flammable fumes.
• Do not place the fan or any parts near an
Fig. 4
open flame, cooking or other heating
Fig. 4
appliance.
• Do not operate any appliance with a
damaged mains cable, plug, after the
D
appliance malfunctions, or has been
dropped/damaged in any manner.
• The use of attachments not recommended or
sold by the appliance manufacturer may
cause hazards.
• Do not use outdoors.
• Do not let the mains cable hang over the
edge of a table or counter, or come into
Fig. 7
contact with hot surfaces.
• To disconnect from the electrical supply, grip
the plug and pull from the wall outlet. DO
K
G
NOT pull on the mains cable.
• Always use on a dry, level surface.
• Do not operate without the fan grills properly
in place.
L
• This product is intended for household use
ONLY and not for commercial or industrial
J applications.
• If the supply cord or plug is damaged, it must
be replaced by the manufacturer or its
service agent or a similarly qualified person
in order to avoid hazard.
• The appliance contains no user serviceable
parts and should the product suffer damage
or breakdown it must be returned to the
manufacturer or its service agent.
• Should the appliance stop working, first
check the fuse in the plug (UK only) or
fuse/circuit breaker at the distribution board is
operating, before contacting the manufacturer
or service agent.
OPERATING INSTRUCTIONS
• NOTE: Use caution when adjusting the tilt (See Fig. 1)
angle of the fan head to ensure that your 1. Make sure the Speed Control is in the OFF
fingers do not get caught. (0) position.
2. Plug the cord into a suitable outlet.
DESCRIPTIONS
3. To adjust speed, turn Speed Control (P)
A. Pole
located on top of Motor Housing (E) to the
B. Glass Base
desired setting:
C. Base Nut
0 - Off
D. Rear Grill Nut
I - Low
E. Motor Housing
II - Medium
F. Rear Grill
III - High
G. Motor Shaft
ADJUSTMENT INSTRUCTIONS
H. Rubber Ring
Tilt Adjustment
I. Prongs
To change the tilting angle of the fan head,
J. Fan Blade
simply move the fan head to the desired angle.
K. Notch on Motor Shaft
Oscillation Adjustment
L. Locking Screw
To start oscillation, press Oscillation Control (Q).
M. Grill Ring
To stop oscillation, pull (Q).
N. Front Grill
O. Grill Ring Screw

CLEANING AND MAINTENANCE

P. Speed Control
• Always unplug the fan before cleaning or
Q. Oscillation Control disassembly.
• Do not allow water to drip on or into the fan
MISSING A PART FOR YOUR FAN?
motor housing.
Please call 0800 052 3615 for assistance.
FAN STORAGE
ASSEMBLY INSTRUCTIONS
It is important to keep the fan in a safe, dry
(see Fig. 1 - 8)
location.
Assembly Time: 10-15 Minutes.
• We recommend using the original (or
Tools Required: Cross Head Screw Driver. appropriately sized) box.
1. Unscrew Base Nut (C) from Pole (A).
FITTING A REPLACEMENT PLUG
2. Fit the Pole (A) and Rubber Ring (H) over the
FOR U.K. AND IRELAND ONLY
opening of the Glass Base (B) and secure
If the plug is not suitable for the socket outlets in
with the Base Nut (C). (Fig. 2 and 3)
your home, it can be removed and replaced by a
3. Unscrew the Rear Grill Nut (D) from the
plug of the correct type. Please refer to
Motor Housing (E). (Fig. 4)
"Installation of a plug" below.
4. Position the Rear Grill (F) over the Motor
Installation of a plug Applicable to U.K.
Housing (E). Fit the 2 Prongs (I) into the
and Ireland.
holes. The handle should be on top. (Fig. 5)
WARNING - THIS APPLIANCE MUST BE
5. Secure the Rear Grill (F) to the Motor Housing
EARTHED.
(E) with the Rear Grill Nut (D). (Fig. 6)
The wires in the mains lead are coloured as such:
6. Remove the protective sleeve from the Motor
Shaft (G). GREEN AND YELLOW - EARTH
BROWN
7. Slide the Fan Blade (J) over the Motor Shaft
BLUE
(G) and tighten Blade Screw (L). (Fig. 7)
Please note that the colour of these mains wires
8. Position the Grill Ring (M) over the Rear Grill
may not correspond with the colour markings
(F) with the Grill Ring Screw (O) positioned at
that identify the terminals in your plug.
the bottom. (Fig. 8)
NOTE: You may have to loosen the Grill Please proceed as follows:
Ring Screw (O).
The wire which is coloured GREEN AND YELLOW
9. Snap the Front Grill (N) into the Grill Ring (M) must be connected to the terminal which is marked
with Bionaire logo aligned in horizontal with the letter "E" or by the earth symbol
coloured GREEN AND YELLOW.
position and tighten Grill Ring Screw (O).
(Fig. 8)
2
The BROWN coloured wire must be connected
to the terminal, which is marked with the letter
"L" or is coloured RED.
The BLUE coloured wire must be connected to
the terminal, which is marked with the letter "N"
or is coloured BLACK.
NOTE: If the terminals in the plug are not marked
or if you are unsure or in doubt about the installation
of the plug please contact a qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA
approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or ASTA
BS1362 approved.
GUARANTEE
PLEASE KEEP YOUR RECEIPT AS THIS WILL
BE REQUIRED FOR ANY CLAIMS UNDER THIS
GUARANTEE.
• This product is guaranteed for 3 years.
• In the unlikely event of breakdown, please take
it back to the place of purchase, with your till
receipt and a copy of this guarantee.
• The rights and benefits under this guarantee
are additional to your statutory rights which
are not affected by this guarantee.
• Holmes Products Europe undertakes within
the specific period, to repair or replace free of
charge, any part of the appliance found to be
defective provided that:
• We are promptly informed of the defect.
• The appliance has not been altered in any
way or subjected to misuse or repair by a
person other than a person authorised by
Holmes Products Europe.
• No rights are given under this guarantee to a
person acquiring the appliance second hand
or for commercial or communal uses.
- LIVE
• Any repaired or replaced appliance will be
- NEUTRAL
guaranteed on these terms for the remaining
portion of the guarantee.
THIS PRODUCT IS MANUFACTURED TO
COMPLY WITH THE E.E.C. DIRECTIVES
73/23/EEC, 89/336/EEC AND 98/37/EEC.
or
3