E) Setting Abs Function - ModelCraft 23 10 21 Bedienungsanleitung

e) Setting the ABS function
With the ABS function you can optimize the braking behaviour of your model car. In doing so,
the braking function is electrically synchronized to avoid a blocking of the wheels. Especially
when driving bends, this is how oversteering or understeering is prevented. Proceed as fol-
lows:
• Turn the transmitter on. In the LCD of the transmitter
the operation mode display appears.
• Now press the set key (see fig. 1, no. 12) eleven times.
On the left side of the display the letters "ABS" ap-
pear under the channel indication "CH2" with the value
that was last set. The default setting is the ABS func-
tion switched off.
• By means of the DT1 button (see fig. 1, no. 3) you can
select one of the following options:
OFF: The ABS function is turned off
FST: Fast frequency of the braking pulses
MID: Medium frequency of the braking pulses
SLW: Slow frequency of the braking pulses
• Five seconds after the last activation of a button, the
value you last set is saved and the display returns to
the operation mode display.
The ABS function mainly is suitable for models with combustion engines and elec-
tric models, in which the speed control is equipped with a braking function. What
settings are best suited for your model can only be definitely found out by practical
driving tests with different settings.
In speed controls with a reverse driving function you should switch the ABS func-
tion off.
Figure 18
61