Spektrum AR6400LBL Bedienungsanleitung Seite 7

THRO/RUDD
Reversing Optional 1.5-Gram/1.7-Gram Servo
Reversing the servo is useful when implementing certain installations, such as dual ailerons, flaps,
etc. Spektrum offers a servo reversing lead you can plug between the receiver and the optional servo.
To reverse servo using the reversing lead:
1. Plug the reversing lead into the servo
2. Plug servo into CH2 or Reversed CH2/CH6 ports
3. Power receiver using a charged battery
4. Once receiver connects, the servo is now reversed
5. Disconnect battery from receiver
6. Remove servo reversing lead (be sure to store your reversing lead in a safe place for future use)
7. Reinstall servo lead into servo port
To Change CH6 to a Reversed CH2 for Dual Ailerons or Reversed CH2 to CH6
1. Ensure the receiver and transmitter are bound
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move Control sticks to the corresponding position to change between the available options (see
illustration)
5. While holding this position, plug the battery into the receiver; power receiver
6. The LED on the receiver will go solid and within 5 seconds the LED will flash 3 times quickly,
indicating the option is now changed
7. Disconnect flight pack from receiver
8. Turn transmitter off
Mode 2
THRO/RUDD
CH4
1. Full THRO
2. Up ELEV
3. Right AILE
ELEV/AILE
Rev. CH2/CH6
1. Full THRO
2. Up ELEV
3. Left AILE
ELEV/AILE
ELEV/RUDD
ELEV/RUDD
7
THRO/AILE
Mode 1
THRO/AILE
EN