Sound Adjustments; Adjusting The Sound - JVC KD-LH401 Bedienungsanleitung

SOUND ADJUSTMENTS

Adjusting the sound

You can set the speaker output balance,
subwoofer output level, and input level of each
source.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Select the item you want to adjust.
• For iEQ (sound mode) settings,
see pages 33 – 35.
• For THEME (display theme) settings,
see page 36.
Indication
Fad Adjust the front
and rear speaker
balance.
Bal Adjust the left
and right speaker
balance.
Sub Out Adjust the
subwoofer output
level and cutoff
frequency level.
Vol Adj Adjust and store
the input level
of each source.
32
The next-step-operation
buttons start flashing.
Each time you press the
button, the adjustable items
change as follows:
To do: Range
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
00 (min.)
|
12 (max.)
Low/Mid/High
–12 (min.)
|
+12 (max.)
2
Make adjustments.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time.
• If you are using a two-speaker system,
set the fader level to "00."
• Press 5 (up) or ∞ (down)
• Press ¢
• To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press ¢ or 4
"Mid," or "High."
Low: Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid: Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz are
cut off to the subwoofer.
to adjust the fader.
or 4
to adjust the balance.
To increase the level
To decrease the level
to select "Low,"